Thingiverse
Gocycle gear cover
by Meffi
2
Downloads
1
Likes
0
Makes
Carbon kinetics take 12€ for this little piece of plastic, and after some days it will breake again... the tiny tooth who snap in are too small and inflexible.
I decided to design an own version of this cover.
Remove the outer rim and the little supports for the covering surface, and do a little sanding.
It fits very tight, be sure you sanded it enough before you use too much pressure.
Layer ->0.3
Infill -> 30% (much useless at all, you can put it from 30-100%)
PLA
200°c
you need a good cooling and a good strategy for the bridging!
Update: Added a second STL for printing upside-down with no supports. Only try this with a lot of air for cooling
I decided to design an own version of this cover.
Remove the outer rim and the little supports for the covering surface, and do a little sanding.
It fits very tight, be sure you sanded it enough before you use too much pressure.
Layer ->0.3
Infill -> 30% (much useless at all, you can put it from 30-100%)
PLA
200°c
you need a good cooling and a good strategy for the bridging!
Update: Added a second STL for printing upside-down with no supports. Only try this with a lot of air for cooling
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!