Golf Ball Lamp

This is a ~12 ½ hour, 202 mm (~8inch) 3D Model Golf Ball Lamp. Modeled to be hollow with the light housing mount built into the model. You will only have to additionally print the bottom section for that mount. The .3mf has it included on the plate.It has manual supports painted for the least amount of waste, but to also be structurally strong for the lower section of the outside and the very top of the golf ball. The support should snap off very easily. Getting the top supports out is a whole other story. They will snap off fine, but will be slightly too wide to pull straight out. You will need to cut it in pieces as it comes out so that you don't risk ruining the model. The model is very structurally strong, however it's still plastic so be careful and take your time. It is worth the patience. Also if you note in the picture, I forgot to change the seam location to “back”, so the irritating dots you see throughout is what caused that (they were set at “random”). This is fixed