Goodman for Sofirn SD01 Dive Torch

Goal is to print a goodman handle for an inexpensive Sofirn SD01 dive torch that puts center mass directly over the handle. It is a heavy torch and a bit awkward to mount on a retail goodman, especially with the rotating magnetic switch that requires some clearance to operate. This one was sized for my hand width in dry gloves and 5/16-8 hardware so a highland delrin speed nut can be used for adjustment, but feel free to remix to your hearts content for your own needs if this looks like a good place to start.

Only hardware required other than the two prints are:
5/16-18 x 1.5" Stainless flat head cap screw
5/16-18 stainless nylon lock nut
5/16-18 delrin speed nut
some 4mm bungie and a stainless bolt snap