Thingiverse

Goofy Pumpkin

by DRPrinting3D

14 Downloads

19 Likes

0 Makes

A hollow pumpkin I designed with a goofy face on it. I used a small section of a white 12V LED strip on the top then glued the two pieces together. There is a small hole in the rear of the base to allow you to run a cable out of the back.

**Note:** The small arrow in the bottom of the top piece points toward the crease in the face.

Source

Thingiverse

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format