Thingiverse
Google AIY Voice Snapbox
von burntcrispy
39
Downloads
36
Likes
1
Makes
This a case for the google AIY voice kit.
It is designed in 6 pieces, each to to be printed laying down.
There are catches on the top and bottom pieces, going into notches on the front and back sides holding the whole thing together.
The mic PCB and speaker also snap into place using plastic catches.
I used the standoffs that came with the kit; They sit in rings on the bottom piece, keeping the raspberry pi from sliding side to side, or pushing in when plugging in the USB.
The back side keeps the raspberry pi from moving up and down and needs to be inserted at the same time as the pi.
The SD card is accessible from the outside (remember to remove during assembly).
It is designed in 6 pieces, each to to be printed laying down.
There are catches on the top and bottom pieces, going into notches on the front and back sides holding the whole thing together.
The mic PCB and speaker also snap into place using plastic catches.
I used the standoffs that came with the kit; They sit in rings on the bottom piece, keeping the raspberry pi from sliding side to side, or pushing in when plugging in the USB.
The back side keeps the raspberry pi from moving up and down and needs to be inserted at the same time as the pi.
The SD card is accessible from the outside (remember to remove during assembly).
burntcrispy veröffentlicht auch auf
7 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
