Google nest audio corner bracket

Printed on an Ender 3

I purchased some wall mounts for my google nest audio, but I wanted to hang to speaker in a corner, so I created this option.

Can use 4 and 5 mm screws (headsize max 8mm) for the wall screws

The screws going from this corner piece to the original wall mount was 4x25mm, and I used at dowel / plug (normally used for concrete walls), to make a tight fit.


PLA
Layer height 0.28
Print in upright position

Infill: 10% for the majority, and 60% for the corners at which screws are inserted.

(printed using cura, using "support blocker" to increase infill percentage at specific spots)

Supports: I used supports, but it may not needed.