GoPro Bed Mount for Flashforge Finder.

Having been looking for a mount for the gopro for the Flashforge Finder i came across this bed print so decided to use part of the design and incorporate a slight incline to set the camera on.

Its not perfect but it meets the needs of having a fixed mount area which will raise with the bed. I unscrewed the front 2 level nuts to slide the mount in from the side, had there been no incline then this would have slotted straight in no issue.

I may revisit this design again later to take out the incline but wanted to raise the camera over the lip of the print area, so will see how it goes.

The main print area that slots under the bed could also do with about 3mm adding as i have packed it with 2 foam sponges. I wanted to under print so i could still use rather than over print and it be useless. the sponges keep the mount really secure and re-leveling the bed is essential.

I haven't taken much care in the post clean up as its just for me but there you go.