Thingiverse
GoPro Gorillapod mount
par PandPP
33
Téléchargements
22
Likes
0
Makes
I printed tkramm's version at 0.3mm layer height, but it wouldn't fit into the Gorillapod.
After I started looking I wasn't happy with the accuracy of the Gorillapod base. The result is that I redesigned the Gorillapod base.
I also wanted the 5mm nut holder to fully capture the nut.
I printed this with support, due to the large overhang on the captured nut.
The slope on the Gorillapod base is 0.4mm over 31.5mm. If you don't print this at hi-res, it quite likely will not fit.
Sorry about the average photos.
After I started looking I wasn't happy with the accuracy of the Gorillapod base. The result is that I redesigned the Gorillapod base.
I also wanted the 5mm nut holder to fully capture the nut.
I printed this with support, due to the large overhang on the captured nut.
The slope on the Gorillapod base is 0.4mm over 31.5mm. If you don't print this at hi-res, it quite likely will not fit.
Sorry about the average photos.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
