Thingiverse
GoPro handlebar mount
von hudson
8
Downloads
7
Likes
0
Makes
You can tune the diameter of your bicycle handlebar and if there is a taper the `gopro-race.scad` supports two sizes.
The M5 nut is a press fit and should go on the right side of the mount. A piece of foam between the mount and the handlebar helps prevent it from rotating. Use good zipties.
The M5 nut is a press fit and should go on the right side of the mount. A piece of foam between the mount and the handlebar helps prevent it from rotating. Use good zipties.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
