GoPro Parts

Here are compatible parts for GoPro. The base and clip(s) have been tested to fit very well together even after good use. Initially it can sit a little too tight, but it will loosen up a little after usage. The spiral fits perfectly into the normal clip. Tighten the spiral with two/three small screws, preferrably with 3-3.5mm head diameter and 10mm thread length (DIN 7981). The "Clip with spiral" part has an embedded camera-mount interface, in case that is preferred.

The knob needs a M5 screw with total length of 40mm, head diameter of no more than 9.2mm (can be less) and thread length of ca. 38mm. Screw the screw into the knob after applying strong glue either on inside of knob, or on screw threads. I've used gorilla glue, and it is permanently fastened.

Two parts need M5 nuts (DIN 934) inserted into slots;
1. Clip with spiral
2. Spiral

I printed some parts with supports. See photos.


For strong and durable parts, print in PETG with high number of perimeters (5< should