MakerWorld
Sport & Outdoors
Ver Modelo
Gopro Vertical Mount
29
Descargas
11
Likes
17
Makes
This is a mount to mount the gopro or another actionCamera vertically on the helmet with a rear mount so as to take up as little space as possible, AN M5 NUT IS REQUIRED.it is necessary to add the nut because threading the model would have made it much weakerDesigned to be used with original screws or not. It is recommended to use a specific material such as PETG or even better ASA to reduce wear on the piece BUT even printing in PLA with the necessary precautions (thick wall and very high filling) is equally fine
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
