Thingiverse
Gothic Nave Section
door syvwlch
248
Downloads
204
Likes
0
Makes
This is a 3D model of a section of the nave of a Gothic church.
I based the height to width ratio on the golden section,and the design of the arches on the basic Gothic proportions, so nothing very new. I hope to add the side alleys and some flying buttresses in a later version.
The only clever trick is the use of little cross-shaped pieces to hold the two parts of the pillars together, one at the base, and one at the top, resting on a little shelf. Since the pillar parts that slot into each other are rather long, you need this trick to keep them from sliding side to side.
I based the height to width ratio on the golden section,and the design of the arches on the basic Gothic proportions, so nothing very new. I hope to add the side alleys and some flying buttresses in a later version.
The only clever trick is the use of little cross-shaped pieces to hold the two parts of the pillars together, one at the base, and one at the top, resting on a little shelf. Since the pillar parts that slot into each other are rather long, you need this trick to keep them from sliding side to side.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
