GPIO Hinged Raspberry Pi B+ case

This print-in-place hinged Raspberry Pi case is a remix of [0110-M-P's design][1].

I made this because I really liked his design but I needed better access to the GPIO pins than the pop-out pieces provided in the origional model.
This design adds a print-in-place hinge that flips out to give easy access to the GPIO pins.

**This is for any of the Raspberry Pi Model B+s and the Raspberry Pi 2**

I have also included the origional bottom file of the Raspberry Pi case.

To reduce [elephant feet][2] fusing the print-in-place hinge on the bottom layer, try setting the "Initial Layer Horizontal expansion" to -0.5mm or so in your slicer.

[1]:https://www.thingiverse.com/thing:922740
[2]:https://all3dp.com/2/elephant-s-foot-3d-printing-problem-easy-fixes/

****Make sure to print WITHOUT supports!****