Thingiverse
GPS Mount (basic) for RC vehicles and multirotors
door Painless360
13
Downloads
15
Likes
0
Makes
This is a basic mount for a GPS unit. The design doesn't include the enclosure for the GPS as those are very model specific. The part here comes in three parts - print two of the mounts with 40% infill for strength and light weight then either print the centre section or simply design the length of mount you want with 4mmx4mm at each end.
The ends are designed to be a snug fit so you may need some light filing/sanding to get them into place.
Best of luck with your model! Thanks for looking..
The ends are designed to be a snug fit so you may need some light filing/sanding to get them into place.
Best of luck with your model! Thanks for looking..
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
