GPS pole mount BN880 Inav

I built a inav quad and needed the GPS to be mount a bit further away from the battery to improve compass performance as i was getting some interference wrt to the magnetometer..

I know this is probably not the right remix to add but i found the GPS holder part to be the best looking to mod. Since the gps needs to take a hit it must be printed with flexible.. I have had a few mild hits and the mount hold up really well.

I used simple tinkercad as i am a newbie.

Thank you for the great simple light design on the gps holder. the entire mount with a 10mm rod (a old rod i saved from my heli days, trex450 boom, finally found a use for it!) weighs around 11-12g's (rod and print) about the same as the weight as the BN880 itself!

Since the screw holds are pretty much the same and so should work with most 5-7 inch frames, or at least the same for all of my frames...