Thingiverse
GPU Fan Mounted Distance For Node 202 Cases
por Raaaww
46
Descargas
22
Likes
0
Makes
MAKE SURE IT IS PRINTED IN A MATERIAL THAT DOES NOT MELT IN YOUR PC CASE!
One of the problems with the node 202 case is that if you put 2x 120 fans next to the GPU you can no longer attach the distance/bracked/thing that takes some of the GPU's weight and keeps it away from the fans.
This mounts ontop of the fans and pushes the GPU away from them. Make sure it does not stop any of the GPU fans(Noctua 120mm fans in picture).
Push it under the GPU where it does not touch any of the fans but still lifts it a bit and then screw into place. Make sure it's tight.
Printed in PLA at 210c (Recomended ABS, PETG or anything with higher heat resistance)
100% infill,
0.2mm layer height,
0.3 line width
One of the problems with the node 202 case is that if you put 2x 120 fans next to the GPU you can no longer attach the distance/bracked/thing that takes some of the GPU's weight and keeps it away from the fans.
This mounts ontop of the fans and pushes the GPU away from them. Make sure it does not stop any of the GPU fans(Noctua 120mm fans in picture).
Push it under the GPU where it does not touch any of the fans but still lifts it a bit and then screw into place. Make sure it's tight.
Printed in PLA at 210c (Recomended ABS, PETG or anything with higher heat resistance)
100% infill,
0.2mm layer height,
0.3 line width
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
