Thingiverse
GPU Holder
von felippeantonachi
10
Downloads
14
Likes
0
Makes
A screw with 4mm in diameter and the head with 8mm in diameter with 30mm of pillar were used.
The base is 65mm high and the top 8mm with the screw at maximum height the support reaches 80mm high. Change the height of the Y axis to achieve a support height of more than 80mm in its final stroke.
The base is 65mm high and the top 8mm with the screw at maximum height the support reaches 80mm high. Change the height of the Y axis to achieve a support height of more than 80mm in its final stroke.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
