GPU Support for cases with bottom mount fans

This is my first 3d model. I needed a GPU anti-sag support that could span over my bottom mount fans. DimensionsLegs are 10mm deep and 60mm wide.Minimum support height is 95mm but you could saw off 10mm from the threaded riser to get that down to 85mm. If you want it shorter, I can add other riser options.Maximum support height is 115mmCross bar width is 175mmPrinting0.2 layers with 15% infill (threaded risers is 25% for a little extra rigity) SupportsSupport is required for the cross barSupport is optional for the threaded riser - i used it just for a cleaner finishSupport is recommended for the legs, without it the bottom of the thread is a little messy. Print them laying down without support if your OK with one side not looking as nice.