Graded Card Hanging Holder Protector

Graded card lanyard holder.Tested with CGC and PSA.FIt is snug with slab in sleeve.Some filament color shrink differently. Slide the back panel in and out a few times before inserting the slab. This will loosen the back plate up a bit if it is a tighter fit. It was very tight when I printed it in white and slid nicely when I printed it in black.Designed to protect slab without a ton of movement. Keyring used to keep slab secure. Holder includes place for 6x2mm magnets but are not needed with the use of a key ring. Boost MeIf you enjoy my designs, please follow and give this model a boost. It helps me keep creating new designs. Lanyardshttps://a.co/d/9x8lKkP Split Key Ringshttps://a.co/d/5aFEViX 6x2mm Magnetshttps://a.co/d/77z7eeY I recommend using loctite gel control or gorilla glue clear for the magnets. (not needed if you use a keyring) Loctite Gluehttps://a.co/d/5Irv5LR Gorilla Gluehttps://a.co/d/hhCdhW1 Commercial License Available on my Patreonhttps://www.patreon.com/cincinnatisqu