Graflex ANH Grip Guide

This is a grip guide used for a Graflex or Replica Parks/Korbanth Graflex for lining up the grips straight. This was measured to specifically fit a Korbanth 2.0 Replica and fit the grips. It was measured to fit very tight with an Inside Diameter of 1.504in/33.20mm and grips that are .505in/12.82mm wide. Each grip is centered every 51.428 degrees. It should fit for other versions as well. This is for the A New Hope version of the saber with 7 Grips.

This is a solution for the DIY folks who have a 3D Printer and didn't want to wait several weeks to order from 3D Printing services/websites.

If you make it, please post pics and show how it worked for you!


Universal Cap:
This cap was made to easily pop on and off either my ESB or ANH Guides.

ANH Cap:
This cap is designed to fit over the ANH Grip Guide only, it will be very tight depending on your printers tolerances, but it will hold the grip guide straight and to the saber. If you're having difficulty fitting it, print the