Thingiverse
Graflex Stand
di Crypnox
11
Download
10
Likes
0
Makes
This is a Displaystand for your Graflex Lightsaber.
I printed it in Anycubic Black PLA in 0.16mm Layerheight.
It took about 27 hours that way but it turned out great.
The Aurebesh letters say "Graflex" as you could have guessed.
i printed it laying on its "back" with the Tree supports in Cura. That way i can print the holderarms without support and only have to support the top of the letters.
The print is rather PLA consuming so check your settings properly before printing.
Mine was using about ~350 grams of PLA
I printed it in Anycubic Black PLA in 0.16mm Layerheight.
It took about 27 hours that way but it turned out great.
The Aurebesh letters say "Graflex" as you could have guessed.
i printed it laying on its "back" with the Tree supports in Cura. That way i can print the holderarms without support and only have to support the top of the letters.
The print is rather PLA consuming so check your settings properly before printing.
Mine was using about ~350 grams of PLA
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
