Thingiverse
Grail Vase
von JobSmolders
20
Downloads
18
Likes
0
Makes
This Vase or Lamp Shade was meant to print using the “spiral outer contour mode” in Cura.
But that didn’t work due to deformation and the print didn’t come out the way I wanted it to. I tried different materials and different printers, but this one is just no meant for a “one layer wall” :-) .
So these Vases where printed as normal ( as a solid), but with 0% infill, 2 wall layers (wall count =2) , 1 bottom layer, and 0 top layers. Also I changed Z seam to “closest” to avoid travel moves that are unnecessary (and thus avoid stringing).
The translucent Lamps Shade one is PET-G, the green one is PLA
But that didn’t work due to deformation and the print didn’t come out the way I wanted it to. I tried different materials and different printers, but this one is just no meant for a “one layer wall” :-) .
So these Vases where printed as normal ( as a solid), but with 0% infill, 2 wall layers (wall count =2) , 1 bottom layer, and 0 top layers. Also I changed Z seam to “closest” to avoid travel moves that are unnecessary (and thus avoid stringing).
The translucent Lamps Shade one is PET-G, the green one is PLA
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
