Thingiverse
Grandfather Clock
door Winslow
396
Downloads
281
Likes
1
Makes
The model is available in two sizes:
The SMALLER MODEL is scale 1:25
Actual size: 2.00cm. x 1.50cm. x 8.00cm. high
The LARGER MODEL is scale 1:12 (the most popular scale for doll houses.)
Actual size: 3.50cm. x 3.00cm. x 15.00cm. high.
The photo showing both models includes an AA battery for comparison.
The clockface is simply a jpeg printed on thin card stock and glued onto the model.
The pictures I used are attached below for you to download and print out:
The models in the photos were printed on my Makerbot Replicator+ at the default settings of 10% infill and a layer height of 0.2mm. Both models are printed standing upright as in the pictures. No supports are required, but a raft is helpful.
PRINT TIMES:
1:25 model - 44m.
1:12 model - 1h. 45m.
See more of my designs at https://www.thingiverse.com/Winslow/designs
The SMALLER MODEL is scale 1:25
Actual size: 2.00cm. x 1.50cm. x 8.00cm. high
The LARGER MODEL is scale 1:12 (the most popular scale for doll houses.)
Actual size: 3.50cm. x 3.00cm. x 15.00cm. high.
The photo showing both models includes an AA battery for comparison.
The clockface is simply a jpeg printed on thin card stock and glued onto the model.
The pictures I used are attached below for you to download and print out:
The models in the photos were printed on my Makerbot Replicator+ at the default settings of 10% infill and a layer height of 0.2mm. Both models are printed standing upright as in the pictures. No supports are required, but a raft is helpful.
PRINT TIMES:
1:25 model - 44m.
1:12 model - 1h. 45m.
See more of my designs at https://www.thingiverse.com/Winslow/designs
Winslow publiceert ook op
14 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!