Graphics Tablet Wall Mount Holder

Description

Wall mounted holder for a graphics tablet and pen case. I specifically designed this for an XP Pen Deco 03 but should fit any graphics tablet 12mm or less in thickness. The pen holder part is 35mm in diameter but has a clamp to keep smaller cases in position.

Assembly

The 2 clamps used to hold the tablet and pen case in place should be attached using M3 nuts and bolts. The tolerances are a little bit tight when actually printing so the clamps will probably need reducing in width and the holes will probably need drilling out with a 3mm drill bit. The cavities for the nuts will probably be quite tight as well. I recommend screwing a nut onto the end of the bolt a little then holding it with pliers and heating the nut with a lighter of blowtorch, then placing the nut in the cavity as the plastic will then stick to the metal and provide a nice tight fit. Just don't be an idiot about it and burn yourself.

Fitting

I left the back wall of the model blank so you can