Thingiverse
Grappling Hook
von IvorLongarrow
4
Downloads
5
Likes
0
Makes
I designed this Grappling Hook to try to recover a drone from a tree...
The idea was to throw tre grappling hook as a slingshot, grab the tree branches and then shake them...
Unfortunately the day I came back to the park the drone was missing! :(
Good Bye Parrot Swing!
Anyway I was very satisfied with this object, so I decided to upload it hoping that it will help some of you! As always I design really easy to print object.
I've used a 25% filling factor because strong resistence was needed.
In the holes you can easily fit bolts up to 4 mm of diameters, but you can loosen the holes to properly fits event greater bolts.
Use proper nuts on both side to lock the bolts.
The idea was to throw tre grappling hook as a slingshot, grab the tree branches and then shake them...
Unfortunately the day I came back to the park the drone was missing! :(
Good Bye Parrot Swing!
Anyway I was very satisfied with this object, so I decided to upload it hoping that it will help some of you! As always I design really easy to print object.
I've used a 25% filling factor because strong resistence was needed.
In the holes you can easily fit bolts up to 4 mm of diameters, but you can loosen the holes to properly fits event greater bolts.
Use proper nuts on both side to lock the bolts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
