Grasshopper 30.5mm stack cover

Hi,
take a look at my other designs https://www.thingiverse.com/BuiltBrokenGlued/designs

I printed this to protect my stack in a 165mm grasshopper frame.

I was finding that landing in grass cause wet cut grass (from the props) was getting to the CC3D and ESC sockets.

It is 20mm high and push fits over the stack. The front space allows room for wiring, from the receiver and CC3D to the 4 in 1 ESC at the bottom. There is a cut out for the aerials and power in to the ESC at the back.

This may not fit your application exactly but it may inspire you to design your own.

I would like to make this into a total cover so I can smooth over the top of the quad and remove the top grasshopper plate.