Thingiverse
Gravestone LED Desk Lamp
di nathandillon
4
Download
8
Likes
0
Makes
The model is recessed to allow for some LED lights to be installed. I used these ones from amazon but you can use any you like. (https://www.amazon.co.uk/Dimmable-Flexible-Self-Adhesive-Commercial-Backlight/dp/B09D7DH376/ref=sr_1_5?keywords=led%2Bstrip%2Bwith%2Bswitch&qid=1689863117&sr=8-5&th=1)
The bottom stand is also recessed in case you wish to use a more complicated light setup and put in a D1 Mini or ESP32/ESP8266.
It's a very simple model that I sketched up, I have left one side open to put in the lights and to allow for a backwash effect. The front wall is very thin to allow light to pass through.
I would ideally use supports but mine printed fine without.
I originally sketched the model in Adobe Illustrator as a flat plane and exported this as a SVG to allow me to bring this into Tinkercad. I then outlined the image in illustrator and done the same and then extruded the height in tinkercad to make the walls.
A very simple model but sufficient enough for my nee
The bottom stand is also recessed in case you wish to use a more complicated light setup and put in a D1 Mini or ESP32/ESP8266.
It's a very simple model that I sketched up, I have left one side open to put in the lights and to allow for a backwash effect. The front wall is very thin to allow light to pass through.
I would ideally use supports but mine printed fine without.
I originally sketched the model in Adobe Illustrator as a flat plane and exported this as a SVG to allow me to bring this into Tinkercad. I then outlined the image in illustrator and done the same and then extruded the height in tinkercad to make the walls.
A very simple model but sufficient enough for my nee
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
