Thingiverse
GraviTilt
by Schleifi123
65
Downloads
31
Likes
0
Makes
Skew blocks to tilt a tile. These blocks have the lowest points on an edge so that "entry and exit" can be on the same height. This is a bit easier (nicer) if the marble runs back and shall take a different exit.
The lower exits are at 5mm height (black height block), the middle exits are and 5.5, 7.5 and 10mm (gray height block)
The lower exits are at 5mm height (black height block), the middle exits are and 5.5, 7.5 and 10mm (gray height block)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
