Gravity comb (with switchable blades)

Description
Remixed from https://www.printables.com/es/model/280491-gravity-knife and https://www.thingiverse.com/thing:1140

I searched for this model for quite a bit but didn't find it, so I decided to do it myself.
There's a space in the middle of the comb blade that's 0,01 mm wider, but I'm too lazy to fix it so it'll have to do XD.

Peg should still be printed twice as the original.

No supports required.
Layer height: 0.2mm
Infill:100% (actually I think you can get away even with 20% in everything but the blades)



27/06/23

Actually got the energy to fix the comb XD

Assembly:
The Peg should be printed two times.
All the tiny blobs or other printing defects should be removed if any.
BaseBottom and BaseTop should be press-fitted. Use glue if needed.
Check if Blade moves smoothly in the Base. Use sandpaper on the blade if needed.
Press fit Peg into the Blade when it is moving smoothly in the Base. Make sure to center the Peg.
Put the Base into the Case a