Thingiverse
Gravity Picture Holder
by mygadgetlife
6
Downloads
27
Likes
0
Makes
This picture holder uses a captive rod to trap the inserted photo or memo.
The model has in-built tabs for stability while printing - set your slicer to ‘No Brim’.
Print with 0.3mm layers for a faster print.
Post printing:
Trim the support tabs from the base.
Cut the internal rod supports with a craft knife.
Remove the sacrificial rod end piece - use needle nose pliers or prise loose with a small screwdriver.
The holder can be attached to surfaces with Blue Tak, Command Strips or double sided tape.
Holder is 100mm (4") long.
The model has in-built tabs for stability while printing - set your slicer to ‘No Brim’.
Print with 0.3mm layers for a faster print.
Post printing:
Trim the support tabs from the base.
Cut the internal rod supports with a craft knife.
Remove the sacrificial rod end piece - use needle nose pliers or prise loose with a small screwdriver.
The holder can be attached to surfaces with Blue Tak, Command Strips or double sided tape.
Holder is 100mm (4") long.
mygadgetlife also publishes on
24 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
