Thingiverse
GRBL Control Board Box
door gizerator
4
Downloads
2
Likes
0
Makes
I'm building a small laser engraver, and i designed a small box for it. There is holes for a 3010 axial fan, for additional cooling. IMPORTANT: I did'nt tested the fans yet so be careful sice then!
The board im using is a chinese one: Bachin CNC GRBL 3axis Control Board
v2 properties:
-Bit higher bottom part,for the screws that holds the fan.
-The fan on this verion is blowing over the X and Y axis stepper
v1 properties:
-Smaller bottom part, so the upper part is closer to the top
-The fan on this version is blowing to the MCU
The board im using is a chinese one: Bachin CNC GRBL 3axis Control Board
v2 properties:
-Bit higher bottom part,for the screws that holds the fan.
-The fan on this verion is blowing over the X and Y axis stepper
v1 properties:
-Smaller bottom part, so the upper part is closer to the top
-The fan on this version is blowing to the MCU
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
