Gridfinity GameSir Cyclone 2 Charging Dock

I made a custom Gridfinity insert for my GameSir Cyclone 2 controller that lets it charge while docked as well as wakes up and connects to my PC when I take it off the dock. The controller comes with a little charging stand, so I took that apart and built the important parts into my print.How I Put It Together:Disassembled the original charger.I opened up the charging dock that came with the controller and removed the PCB and the pogo pin piece. At this point I accidentally broke a solder joint. One of the connections on the PCB snapped while I was taking it apart. If you’re careful, you can probably avoid this. I fixed it using some small jumper wires (colored ones you see in the photos). Mounted the pogo pins.I designed a small wedge as part of the print that holds the pogo pin board at the right angle. I screwed the board into the wedge and then super glued that wedge into the front cavity of the Gridfinity block.Secured the PCB.Once the pins were wired up and in place, I positioned