Gridfinity HF/Pittsburgh Nut Driver Set SAE

Found a few other options for these Pittsburgh nut drivers from Harbor Freight, but they all took up too much space (1x5 for each driver, or 5x7 for the set). Since space is at a premium in my tool chest, I squeezed these into a 5x5 plate. This may work for similar drivers, so I've also included a cross section of the tray to test out if your drivers will fit. It takes about an hour to print. Saves you from printing the 6-7hr file only to find out it doesn't work for your drivers.There are 2 versions of the main tray, one where the shaft-end is extruded further to allow you to push down on the shaft, thus making it easier to pull the drivers out. I don't think it's necessary on these tools, but doesn't hurt. Obviously no need to print both plates.I used the same size ‘driver head’ for all, so the smaller ones will have some space around them, but it saved me time when modeling.I made both sets, SAE and Metric. Check my profile for the other one if needed.Please let