Gridfinity to Car Vent Adapter

TLDR - Screw these onto Gridfinity bases that have the 3mm holes in the corners. Use M3x12 low profile fasteners. Clip into your car's air vents. Enjoy boundless organization bliss.Goes great with my Gridfintiy Dipping Sauce Holder! Printing:Prints on it's side, no supports needed.I printed it in PETG. ABS/ASA would also work great. Skip PLA if you can since it's inside the car.Installation:The hole in the back of the adapter clip is tapered, so just screw in your M3x12 fastener and you should be good to go as long as you don't over tighten it. (https://amzn.to/45zDdQB affiliate link to fasteners)There is a little bit of side to side rotation on purpose. This will allow you to adjust the clip a little if needed so it doesn't hit the knob or adjuster in the vent.One clip will probably work for single bases and small stuff, but two or more clips is recommended.Confirmed to work with these bases, likely fits many more:https://www.printables.com/model/300603-gridfinity-