Gridfinity Worx Tray

IMPORTANT: The tray requires 5x3 Gridfinity spaces, but the box slightly reaches over the edge lengthwise! (5x Gridfinity = 209,5mm / Toolbox length = 213mm)Introduction:Since I started my own Gridfinity project I designed this simple, fast and lightweight (100g) tray for the Worx Rotary Tool, to keep it from moving around in my drawer.The tray has a 0,6mm (= 3 layers) deep Worx logo engraving on the bottom, which is obviously just for aesthetics, but I think it looks quiet nice. I also added a plate with a model, which doesn't have the logo engraved in it. Printing:Since the overhangs are minimal, the model does not require any supports.I changed the Grid Infill to 5% to make the model as lightweight as possible, since it's really only for holding the box in place.Please note that the top surfaces don't look that nice due to the low infill, you can increase the infill or enable ironing the top surfaces (takes twice as long though).Dimensions:Outside: 209,5 x 125,5 x 20,4mm