Thingiverse
grip assist
von Henryhere
1
Downloads
2
Likes
0
Makes
Ball end for wall scraper.
In order to get more purchase when using the hand scraper found myself using the palm of my hand on the end of the shaft. This after a while becomes a pain, especially when the foam grips move.
Made this ball to alleviate the point pressure on my palm.
The diameter of the shaft was 19.5mm ish, therefore made the hole diameter 20mm.
The ball diameter is 80mm. When using this I felt that it may have been better to go 60 or 70mm diameter for my "medium" hands. But it worked as it was and I didn't have large amount of scraping left to do so didn't design/print another one.
Sketchup 2017 file included for any "tweaks" that may be necessary.
In order to get more purchase when using the hand scraper found myself using the palm of my hand on the end of the shaft. This after a while becomes a pain, especially when the foam grips move.
Made this ball to alleviate the point pressure on my palm.
The diameter of the shaft was 19.5mm ish, therefore made the hole diameter 20mm.
The ball diameter is 80mm. When using this I felt that it may have been better to go 60 or 70mm diameter for my "medium" hands. But it worked as it was and I didn't have large amount of scraping left to do so didn't design/print another one.
Sketchup 2017 file included for any "tweaks" that may be necessary.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
