Thingiverse
Groove mount adapter
by Gormadt
15
Downloads
14
Likes
0
Makes
This is a groove mount adapter that fits into the Titan extruder to mount it to a CR10 V2 or V3
The threaded bit is an M10x1 that is 8mm long
It screws right into the top of the hot end to mount a titan extruder
Print with at least 0.15mm layer height if not finer
Also print it thread side up and you shouldn't need supports
The threaded bit is an M10x1 that is 8mm long
It screws right into the top of the hot end to mount a titan extruder
Print with at least 0.15mm layer height if not finer
Also print it thread side up and you shouldn't need supports
Gormadt also publishes on
22 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
