Groovy Vase

I designed this from many many Icosahedrons' overlaid on each other. Then had fun with the formation. Vase mode print, make sure to use that mode in your slicer. Prints without supports and I recommend at least 1mm walls, 1mm wall is the max width for a .4 nozzle. I recommend printing with a .6 nozzle and use 1.5 line width. If you don't know you can extrude 2.5 times the nozzle width, for example .6 x 2.5 = 1.5mm, this is true for a .4 nozzle too. Max is 1mm for a .4 Nozzle.I hope you enjoy this model DWTC