Thingiverse
Groovy Watering Can
3
Downloads
10
Likes
0
Makes
Just a simple watering can with a cool design and some grooves.
To make the print watertight it is recommended to use the highest temperature that the given filament supports. Aslo set the wall line count to 6 or 8 so that the walls are made of only wall lines with no infill between them. The infill can be set to 0%, this way the handle will have its own separate void as shown in the picture.
No support needed
Despite the efforts, some water might still leak out of the can very slowly if it is kept full of water for a long time.
To make the print watertight it is recommended to use the highest temperature that the given filament supports. Aslo set the wall line count to 6 or 8 so that the walls are made of only wall lines with no infill between them. The infill can be set to 0%, this way the handle will have its own separate void as shown in the picture.
No support needed
Despite the efforts, some water might still leak out of the can very slowly if it is kept full of water for a long time.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
