Grr-Ripper Spacer

If you need to cut strips 1/4" or narrower on your table saw, this simple little spacer allows you to do so without chewing up your Grr-Ripper push tool. Other alternative is the 1/8" leg accessory which is a bit pricey. I have ordered a couple of the legs from Amazon and when they arrive I will do a shoot out with this. You need a couple of #10 x 1" screws also and funnily enough I had to use #8 washers as my counter bore was too small. Still worked. Also you need to set your blade less than 3/8" above your workpiece to avoid the spacer.