Thingiverse
gscartsw vertical stand
by mondog
4
Downloads
4
Likes
0
Makes
Vertical stand for the gscartsw from gRetrostuff store.
One side wall is lower than the other to allow for nuts that stick out of the bottom of the case.
Having the LED side down will allow the cables to stick up (see picture).
There are two versions, one with a slot to accommodate the middle screw - this one stays at the mid line. The one without the slot can be inserted at the first or second half (on either side of the middle screw).
Measures 9 cm long x 9.8 cm wide. The slot is 28 mm wide.
One side wall is lower than the other to allow for nuts that stick out of the bottom of the case.
Having the LED side down will allow the cables to stick up (see picture).
There are two versions, one with a slot to accommodate the middle screw - this one stays at the mid line. The one without the slot can be inserted at the first or second half (on either side of the middle screw).
Measures 9 cm long x 9.8 cm wide. The slot is 28 mm wide.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
