GT2 Belt Clip

Clip for joining 2 ends of a gt2 belt for my migbot i3. The tolerances are kind of tight, so I had to pry open the insert in order to fit my belt in snugly.You can slide the cover over the belt, insert your ends into the insert piece, then slide the cover over the insert. Cover is also pretty tight on the insert, so if you would like to scale it up a touch to get it to slide over easier, then feel free. I liked mine tight so I could make sure nothing was going to fall off.Check out the original at https://www.thingiverse.com/thing:4111957 for just an end piece or loop pieces as well :)