GTFO Glow Stick

GTFO Glow Stick
================

Model of the glow stick from the game GTFO
---------------------------------------------------------

The glow stick requires a total of 9 socket cap screws:

* 6 X M3 X 6mm
* 2 X M4 X 6mm
* 1 X M5 X 6mm

(I didn't have 6mm screws so I used 8mm and they sticks out a bit more than it should in the picture)

The top and bottom cap pieces have a very small foot print so I recommend using a brim. I was able to print this without supports but I have had it come off the plate once or twice. I also I recommend cutting the hook and body in half down the side for a clean print with no supports.

There is a cavity inside the stick for some ways to make the thing glow. I tried using a translucent filament and glow in the dark paint on the inside but it isn't very successful. The white one printed with the clear PLA filament glows kinda ok but the green and red are pretty dull.

If you liked this, consider fueling my cravings for [coffee](ht