Thingiverse
Guitar Floating Wall Mount
von Brandonmh83
181
Downloads
171
Likes
3
Makes
Print in PETG or Abs. DO NOT USE PLA
Needed to hang one of my old guitar from when I was a kid, not a fan of the standard vertical hanging wall mounts wanted my guitar to look like it was somewhat floating. Will possibly make a new design. This you just drop the guitar into the slots.
The guitar strap mounts fit in the slots which on this model there 13mm.
Screws are 10od head 5mm threads
Left Mount has a 20 degree angle to form to the guitar the right is vertical.
Needed to hang one of my old guitar from when I was a kid, not a fan of the standard vertical hanging wall mounts wanted my guitar to look like it was somewhat floating. Will possibly make a new design. This you just drop the guitar into the slots.
The guitar strap mounts fit in the slots which on this model there 13mm.
Screws are 10od head 5mm threads
Left Mount has a 20 degree angle to form to the guitar the right is vertical.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
