Thingiverse
Guitar Pickup Bobbin (Parametric)
von failrate
34
Downloads
16
Likes
0
Makes
Based on the pickups in a Gibson Epiphone. Sadly, I don\'t think it could be MakerBotted, unless it was done in two pieces. It\'s intended to be laser-cut in layers out of cardboard.
Of course, real bobbins are dirt cheap (about 2.50 USD), but the .scad file can be hacked to make custom bobbins (super-large, super-small, different magnet counts, etc.).
Not yet tested.
Of course, real bobbins are dirt cheap (about 2.50 USD), but the .scad file can be hacked to make custom bobbins (super-large, super-small, different magnet counts, etc.).
Not yet tested.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
