Guitar Wall Mount - Generative Design

Guitar wall mount that was designed using generative design. This is a reworking of the direct generative design. The direct output was unprintable. Must be printed is something other than PLA. I suggest ASA but PETG should also work. PA wouldn't be a bad choice either. PLA is hard and can mar the guitar neck. PC would have the same hardness issue, scratching the guitar neck. ASA/PETG/PA are soft and should not damage anything. NOT RESPONSIBLE FOR ANY DAMAGES. You assume the liability by downloading. Print needs support :( Tree support recommended. Model is based around an acoustic guitar neck. Also tested with a electric guitar for weight and fit. I also made a version that prints without support. Check it out here. https://makerworld.com/en/models/125899#profileId-136073