Thingiverse
Guitar wall mount
by XYZ_Pierre
181
Downloads
204
Likes
5
Makes
Nice looking guitar hanger with a robust thickened wireframe structure.
Can be screwed to a wall qith 3x 4mm screws.
Guitar neck widths available: 44, 46, 48, 50, 52, 54 mm
My classical guitar has a 52mm neck so I used that one.
Always chose the dimension that is equal or slightly higher than the neck of your own guitar.
I have tested it for a classical guitar an it works perfect. If you have an electrical guitar, please do some tests before you leave your guitar there hanging to ensure the print is strong enough, as they are a little heavier.
If you need some change/customization just tell me and I can change and add the needed model.
Can be screwed to a wall qith 3x 4mm screws.
Guitar neck widths available: 44, 46, 48, 50, 52, 54 mm
My classical guitar has a 52mm neck so I used that one.
Always chose the dimension that is equal or slightly higher than the neck of your own guitar.
I have tested it for a classical guitar an it works perfect. If you have an electrical guitar, please do some tests before you leave your guitar there hanging to ensure the print is strong enough, as they are a little heavier.
If you need some change/customization just tell me and I can change and add the needed model.
XYZ_Pierre also publishes on
7 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
