Thingiverse
Music
Zum Modell
Guitar Wall Mount
15
Downloads
7
Likes
0
Makes
Before printing check if its dimensions are compatible to your guitar (see the attached sketch).
I attached the 3mf slicer file. There is a modifier in it with higher infill for the area around the hole for the mounting screw.
In addition I printed it with 3 perimeters (better print it with 4 perimeters, with 3 it seems to be a little fragile) and few infill (10 or 15 %).
As I printed it with ASA I was able to smooth down the surface with acetone fumes.
ABS, PLA or PETG should also work fine.
I attached the 3mf slicer file. There is a modifier in it with higher infill for the area around the hole for the mounting screw.
In addition I printed it with 3 perimeters (better print it with 4 perimeters, with 3 it seems to be a little fragile) and few infill (10 or 15 %).
As I printed it with ASA I was able to smooth down the surface with acetone fumes.
ABS, PLA or PETG should also work fine.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
