Thingiverse
Gurtner PY carburetor float
par G3ox
7
Téléchargements
1
Likes
0
Makes
Gurtner PY carburetor float used in a lot of 50cc mopeds.
I designed this one for my Peugeot Ludix because my original carburetor float broke and a new one is rare and expensive
Print flat on bed with supports all around with a 0.1 or 0.15 layer height and made from PETG. Print with multiple perimeters so it will be water tight and with 5% infill so it will be very light and work properly.
THIS PART MUST BE PRINTED FROM PETG OR IT WILL MELT IN GASOLINE!!!
Some clean up and sanding may be necessary in the needle area.
I have been using it for a few months and do not have problems so far.
I designed this one for my Peugeot Ludix because my original carburetor float broke and a new one is rare and expensive
Print flat on bed with supports all around with a 0.1 or 0.15 layer height and made from PETG. Print with multiple perimeters so it will be water tight and with 5% infill so it will be very light and work properly.
THIS PART MUST BE PRINTED FROM PETG OR IT WILL MELT IN GASOLINE!!!
Some clean up and sanding may be necessary in the needle area.
I have been using it for a few months and do not have problems so far.
G3ox publie également sur
20 modèles supplémentaires sur 1 autres plateformes
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
