Gweike M3 Hinge Drill Guide

I had some issues with the hinges for the lip of my Gweike M3 Ultra. I found that some screw holes were drilled off location at the factory and they needed to be repaired. Included are a spacer block that acts to space the lid the correct distance for the hinge and acts as a drill guide to use a 19/64" drill to install rivet nuts in place of the threaded holes in the sheet metal. Also included is a flat plate that acts a guide to check hinge screw hole location. Required Supplies:Drill11/64" Drill M5 Rivet NutsUse Steps:Screw Spacer Block to M3 lidAlign lid to frame side hinge holes.Use 11/64" drill to drill new hinge bolt holesUnscrew Spacer Block from LidInstall M5 rivet nutsInstall hinge